NEW & IMPROVED* version of Glock rear sight tool that works on almost all
THIS IS THE ABSOLUTE BEST 3D PRINTED TOOL YOU WILL FIND ANYWHERE! THE REDSIGN
KEEPS THE SLIDE SOLIDLY IN PLACE AND THE SIGHT IS PUSHED FROM THE LOWEST
POSSIBLE POINT TO AVOID BINDING!
TOOL WILL INSTALL OR REMOVE SIGHTS OF ALL KINDS, INCLUDING SUPPRESSOR
HEIGHT, UP TO 12MM TALL***
This is a simple, effective and inexpensive 3D printed tool that will get the
job done without the extra cost. Being that it is 3D printed, it is plastic and
the benefit is you don't have to worry about scratching, marring or otherwise
damaging your slide or sights. This tool may gouge plastic sights, which
shouldn't be an issue if you're replacing the factory sights with metal ones.
This tool WILL NOT work with the following Glock pistols:
43, 48, Gen5 22/23, 21, 30, 30SF and all .45GAP and 10MM Glocks.
For a UNIVERSAL tool that works with ALL glocks, please see our other listing:
Instructions for use:
Always follow all firearm safety procedures when handling or performing any
work on firearms.
Glock sights MUST be removed by pushing to the right and installed by
pushing to the left!
All new sights should be fitted to firearm slide by a qualified gunsmith -
new sightsmust be fitted by filing the sight dovetail for proper fitment.
This tool is designed to provide adequate torque for installation of sights
if tool deformation occurs at any point,STOP! Sights should fit without
excess force, and if excess force is required, sight fitment is not as it
should be. New sights should be able to slide above a third of the way into
the dovetail by hand properly fitted.
Please follow all manufacturer's installation instructions and these
guidelines when using this tool.
For any questions or assistance in installing sights, please contact the
We cannot be held liable for any damage or injury caused by using the tool
you will receive.
No sights or other firearm parts will be included in this sale. Color will be
random and can be different than the colors shown in the photos.
The "handle" portion of the tool is removable. This is completely normal.
Please refrain from using a wrench, socket or power tools on the bolt unless
absolutely necessary. Using a tool other than the included 3D printed handle
will apply too much torque and may damage your sights or the tool.
Shipping will be with USPS First Class mail
Thank you for looking and stay safe!